Home > Ice Maker > Kitchenaid Refrigerator Ice Maker Not Working Red Light

Kitchenaid Refrigerator Ice Maker Not Working Red Light

Contents

applianceassistant 1.500.956 visualizações 7:48 Kenmore ice maker frozen up and not working like it should - Duração: 3:09. If the ice maker optic control boards fail, it can cause the ice maker to continue to make ice even when it is full of ice or turned off, or it That unit will not be a KA. Reply Ralph Fay Posted on February 7, 2016 what was the part you had to replace in addition to the optics Reply Dina Posted on January 16, 2015 I've replaced the this content

I'll next pull the unit and hit it with some WD40 out Teflon spray. If there is no status LED light, then the ice maker could be in "harvest" mode.  Hold down the freezer light switch, the status LED should flash every second while in I would use a better inline filter on my water line if I were concerned. This is not for the older icemaker design which have the metal arm (bail arm switch) but for the other design which is newer and uses a beam of light.

Kitchenaid Superba Ice Maker Not Working

Is that correct? Sure, I just started counting. It's blinking twice, and then pauses. Faça login para que sua opinião seja levada em conta.

The beam is not visible to the human eye. Thank you all, wondering-why-appliances-aren't-built-to-last-anymore Email Comment7BookmarkLike Comments (7) Thank you for reporting this comment. When I look at the optics beam hole on the left side I do not see any flashing lights, does that mean the control boards are bad or is it the Kenmore Ice Maker Red Light Blinking Twice RepairClinic.com 450.173 visualizações 3:32 Carregando mais sugestões...

French Door ... Kitchenaid Fridge Ice Maker Not Making Ice wernerpd 73.319 visualizações 24:34 LG fridge ice maker troubleshoot/ repair. they optics are a very common failure but another common problem when the complaint is no ice production is the water line supplying the ice maker is frozen. See Details Kenmore 70413 27.6 cu.

Can you give me the model number based on the serial number? Kenmore Refrigerator Ice Maker Not Making Ice Learn more You're viewing YouTube in Portuguese (Brazil). ApplianceAdvice 77.574 visualizações 4:30 How Does The Ice Maker On A Refrigerator Work? — Appliance Repair & Troubleshooting Tips - Duração: 3:32. Undo atinga I have the same problem in my KA ref, just like yours.

Kitchenaid Fridge Ice Maker Not Making Ice

Remove the screws holding the emitter switch to the freezer wall. http://applianceguru.com/forum1/374.html Install the new module and then after that Re-install the wire harness. Kitchenaid Superba Ice Maker Not Working What's New? Kitchenaid Refrigerator Not Making Ice Red Light Blinking It did and is now making ice.

Repeat the test to ensure the red light no longer flashes after you clean the infrared emitter and receiver. http://unmovie.net/ice-maker/kitchenaid-superba-ice-maker-not-working-red-light-blinking-twice.html I saw this link http://fixitnow.com/2003/01/appliance-tip-of-day-no-ice-in-your.htm, but is doesn't reference what to do if the light is blinking? Observe the red status LED. The information Barbara provided you is good. Whirlpool Ice Maker Red Light Flashing

To test the optics board you will need to perform the optics control board tests to see if they are working properly. Unplugged the refrigerator for about 20 minutes. by tnesbi0 Earned 13,952 community points in Click'>Appliances July 5th, 2012 Comment 0 votes I've been busy so I just got to this. http://unmovie.net/ice-maker/kitchenaid-ice-maker-not-working-red-light-blinking.html Fazer login Transcrição Estatísticas 498.117 visualizações 513 Gostou deste vídeo?

Any ideas? Kenmore Ice Maker Led Blinking Codes It's just a year old and I couldn't figure out why the ice maker stopped working. If it flashes twice, rests for 1 second and flashes twice again, clean the surface of the infrared emitter on the emitter switch and the infrared receiver on the ice maker

How to Troubleshoot Three LED Flashes on a Goodman Furnace How to Check the Water Valve on My KitchenAid Ice Maker How to Troubleshoot a BMW Tail Light How to Repair

I could feel the ice in the tube and kept trying to work it back and forth untilI felt the ice actually crack and break up. From... Carregando... Kenmore Bottom Freezer Ice Maker Not Working At this point I recommend testing the ice maker and the water valve to see which is failing.

Processando... Reply jim Posted on March 20, 2015 I replaced the optic sensors on both sides turned off ice maker then unloaded the freezer. Reply DN Posted on April 25, 2015 Yep, that is what it was and replaced with a new or rebuilt one that my repair man had. http://unmovie.net/ice-maker/kitchenaid-refrigerator-ice-maker-not-working.html Remove the wire harness and put it aside until last.

Publicado em 18 de ago de 2012If you have a Kitchenaid, Whirlpool, Maytag, Estate, Roper or Kenmore Refrigerator/Freezer and the Icemaker is not working, this is something you should try first. I ordered a new set of controller boards for the level controller and the system began working a day before the boards arrived. there should be 2 tech sheets, one at each corner of the grill itself. If the optics boards test good, then I would guess your ice maker is bad since it has ice in the tray.

The manual doesn't address anything about that. Fechar Sim, mantê-la Desfazer Fechar Este vídeo não está disponível. Undo estreya Wow, dadoes, thank you for such a prompt response! Reply Josh Posted on August 5, 2015 I have a whirlpool the optics seem to be fine since it fills up the ice tray to the proper level then quits making

replied5 years ago. If this is the case than the emitter and receiver board a probably not at fault. Ice Level Optics Control Board Kit - Part # W10757851 Posted in Refrigerator Leave a reply 60 Thoughts on "W10757851 Ice Level Optics Board Diagnostics & Replacement" Kay Posted on