It was packaged in a plain white box with no accessories at all. If the metal contact on your power button is still in tact, the power button cable itself is the issue. You should easily be able to tell the difference. That's also nerve-wracking. have a peek here
Add to Want to watch this again later? Reply kuldeep patel says: August 28, 2016 at 7:49 pm hi, I have a iPhone 5 and its is showing eligibility for replacement . The sleep/wake button is located on the top of your iPhone 5: Eligibility If your sleep/wake button isn’t working properly, please enter your iPhone 5 serial number below to see if thinking I might damage the pcb, I just did a power cycle (disconnecting the battery) and now it's fine. https://www.apple.com/support/iphone5-sleepwakebutton/
If you have trouble peeling the battery up, use an iOpener or hair dryer to heat the rear case of the iPhone and soften the adhesive. Information as of 2015-03-05 Apple Footer Apple Support More ways to shop: Visit an Apple Store, call 1-800-MY-APPLE, or find a reseller. If Apple says your iPhone 5 is not part of the program, you won't get a replacement unless it's under warranty. He ended up having to pass me off to a supervisor because some issue was preventing hime from being able to complete the request.
I bought my iphone second-hand, so even though my phone qualified for their program, the store couldn't fix it. Iphone 5 Lock Button Repair Cost The iSclack is designed to safely open your iPhone just enough to separate the pieces, but not enough to damage the home button cable. Refer to the photo below.
I normally guide it in with my finger and then use the screwdriver.
Including a new iPhone 5s/5c. Iphone 5s Power Button Replacement Be sure when you're doing this that no cables in the frame get stuck underneath the logic board. Mike 43,904 views 0:59 iPhone 5 Broken Glass replacement start to finish - Duration: 1:08:04. Once the round wifi connector has disconnected, you can pull the logic board completely out of your iPhone 5.
Be very careful to only pry up on the battery connector and not the socket on the logic board. You can try that method but I suggest following my instructions below instead. Iphone 5 Power Button Replacement Price Now use your spudger tool in order to gently pry the connector off the board as shown. Iphone 5 Power Button Not Working How To Turn On I had some command strips, but I think any double-sided tape could work.
So as long as you have a #000 you should be set! navigate here Reply Apple is bad says: November 20, 2014 at 2:47 pm Yes, Apple will fix this issue for free IF it was manufactured before April 2013. There are two ways to send your iPhone to the repair center—carry-in or mail-in. As useful as the comment about using the plastic tab was, mine was slightly cut by the edge of a flat cable, it split and the tab came off, making prying How To Fix Iphone 5 Lock Button Without Taking It Apart
If you continue to have trouble, try posting a question in our forum for faster feedback! alsmith1928 - 12/18/2014 Reply One of the screw is completely stuck and I cannot remove it! I just kept it attached and kept it at an angle as I pulled with gentle, continuous force (at a 45 degree angle as suggested) on the battery pull tab. Check This Out The side towards the battery some times tends to stick up a bit, this in turn will put pressure on the backplate of the screen.
Raistlin - 08/11/2013 Reply When you reverse step 7, make sure you clip the little hooks of the bracket under and then lower towards the outside of the phone. How To Fix Power Button On Iphone 5 Without Taking It Apart nathan domeij - 01/20/2014 Quick tip: Don't completely peel away the plastic from the base of the phone. If your power button is broken (and judging by the amount of people that read this article every day, that's a lot of you), and it's not an iPhone 5 eligible
You can go right here and enter your serial number (found in Settings → General → About). Take care not to lose it when removing, and make sure it gets back into the right place—a magnetized screw may interfere with the compass. 25 comments Anyone have any idea Now remove the SIM tray from your iPhone 5. Sleep Wake Button Iphone 6 Luckily it didn't break the glass.
While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the front panel assembly from the rear case. Now remove the five screws shown in the photo below. I severed the ribbon and now those buttons don't work anymore. this contact form Comments My iPhone's off button - the power-off button, lock button or whatever you call the button at the top of the iPhone - has stopped working.
Replace the SIM tray in your iPhone 5. Using your ##000 screwdriver to remove the three screws holding the display shield down. It's easy to confuse screws, especially if you go past these instructions to remove everything required to replace the ribbon cable that is necessary for the buttons. How much do they charge for a replacement?
Adam Engst - 03/03/2014 Reply The hint to disconnect the battery was very useful for my successful repair. jjensik11 - 03/04/2014 When reattaching the screen, please start from the top. Nonetheless, it's easy to check to see if you are eligible for the free repair service. Not all iPhone 5 devices have a broken power button, and the the vast majority work as intended.
Gear VR: Which is the best mobile VR device? Be sure to line up the grooves in the top of the screen inside the frame. These are unnecessary steps. I have an open lcd top part of this phone.
Wade Whitaker - 10/12/2015 Reply I initially had trouble, but focusing on the area of the faceplate right above the headphone jack worked for me.