Home > Not Working > Iphone 4 Earpiece Speaker Not Working

Iphone 4 Earpiece Speaker Not Working

Contents

Ordered one but through trial and error determined that by holding the phone upside-down and re-inserting the headphone jack several times I could get the earpiece to work again eventually. Turn your phone upside down and get a blow air inside the jack the stronger the air the better all I had to use was a small compressor. Got the case back on, put in the new screws, and powered the phone on without problem. charlesholt - 09/17/2011 Reply Just wondering if it is possible and where to get one of those indicators edward - 10/02/2011 Reply what are you talking about here??? have a peek here

Julian Boilen - 02/10/2014 Reply My small gold prong fell off, what do I do now? aarone76 - 08/21/2012 Reply Add Comment 1024 Embed this guide Choose a size and copy the code below to embed this guide as a small widget on your site / forum. The 5-Point Screwdriver should only be used once, as it has the potential to strip the screws. 17 comments Caution: New phones may contain T1 screw heads instead of Phillips. My LCD and digitizer now does not work, but I don't think I have any screws in the wrong place.

Iphone 6 Ear Speaker Not Working

I suggest that Step 5 is more explicit about the orientation of this ground connector. Shut it off and when it rebooted it seemed to work. Looking forward to replacing the battery in my other phone that has the pentalobe screws. Many thanks!

Vernon - 01/29/2012 Reply I did it!!! Thanks guys and hope this bit helps! I assume this to be some kind of head-conductive component. Iphone Ear Speaker Not Working Water I was extremely nervous but I believe I got it back in properly.

I used 5 egg indentations to replace my screen. Are you kidding me!! I mean, what's up with that? https://www.ifixit.com/Guide/iPhone+4+Earpiece+Speaker+Replacement/4333 Sign in 39 Loading...

Perform a hard reset after reassembly. Iphone 4 Ear Speaker Not Working Solution Got it in and it worked. Remove the back plate Using your security screwdriver, remove the 2 screws on either side of the dock connector port.Set them aside. The panel will move about 2 mm. 8 comments how can i take out the screw if it is stripped Manny Chaidez - 03/26/2012 Reply with a small driller, but I

Iphone 5 Earpiece Not Working

Phew. https://www.cnet.com/news/no-iphone-audio-speaker-or-earpiece-not-working-a-simple-fix/ I found out that I had broken the tiny jumper on the main board when I pried off the headphone plug. Iphone 6 Ear Speaker Not Working The other was over some large brown sheet of unknown function (though I think it goes over the battery). Iphone Earpiece Not Working But Speaker Does Cancel Mitch Rush Rep: 5.2k 6 2 4 Posted: 01/10/2013 Options Permalink History Usually that would be only the earpiece, that's where I would start, a link to the part, https://www.gounlock.com/details.php?ite...,

Now...what if i snapped the wifi antenna cable together with its male connector from the board? http://unmovie.net/not-working/iphone-3gs-earpiece-speaker-not-working-after-screen-replacement.html The wire on the bent is half-cut. AirPhonesApp - 10/02/2014 Reply all those teeny screws...and the world is so...well...BIG! What - July 9 Reply Stuck on searching after unplugging and plugging in the battery? Iphone Ear Speaker Very Quiet

This is the reason why their is simpler guide: iPhone 4 Battery disconnection to be used when there is no necessity for removing the battery. The bottom screw on my phone was locked with some thread adhesive, and required more force to loosen it than I expected. If all went well your iPhone should boot up and show the Apple logo. Check This Out bluezzer - 10/29/2013 I did not remove the battery to do a Speaker replacement and had no issues with getting the Speaker out/in.

Can I get a replacement screw? Iphone Ear Speaker Replacement You can see it a little at the top of the picture. Steve or someone -- can you explain what is meant by this?

I used this link to refer to: iPhone 4S Battery Replacement Ruth Kaldor - September 8 Reply Add a comment Add Comment 1024 Step 6 Edit Use the clear plastic pull

It should come up easily so pry up gently.You'll notice that it is wrapped around a metal clip. Mark - 03/22/2012 Reply Make sure not to pry too much under the flex cable because you will likely damage the gold / silver shining adhesive tape that is located beneath After resetting the network settings in settings it did work perfectly! Iphone Earpiece Not Working After Water Damage BE CAREFUL when you put the new battery inside!

What affect does this have? I attempted the removal but decided not to in the end. Had 40% charge, all seems well. this contact form So frustrating.

NOW IT WORKS! Am I just screwed forever? Replacement earpiece - Buy now 5-point security screwdriver - Buy now Standard #000 Phillips screwdriver - Buy now Spudger tool - Buy now Razor blade - Buy Now iSesamo Opening tool The nut or washer or whatever it is that you mention has gone.

Use extreme care and caution when performing a repair on any device. I see others have had this problem. Now you should be able to lift the logic board out of the iPhone. The earpiece speaker grill was clogged after I accidentally spilled coffee on the phone and was unable to hear my calls, oops.

once i snapped this in place the second time, it worked like a charm. I replaced myself using tutorial from Ifixit.com and it took me around 40 minutes. Otherwise you will not be able do step 13.